Hello!
I posted a message a week or so ago,
and noone answered. Probably because I didn't
give enough info. I have a card with a 21140A
and will not switch between 10Mbs or 100Mbs
modes, unless I bring the interface down, switch
networks, then bring it back up.
There are no other problems, the card
works fine in either speed setting. I just am
unable to switch between 10Mbs and 100Mbs without
bringing the interface down.
I had to write a new Media Description
table to get this much to happen. Previously
I had to reboot to switch media.
Any ideas or answers or anything would be greatly
appreciated.
The card by the way is an RNS2300 (Rockwell
Networking Systems).
-- Mike B.
This archive was generated by hypermail 2b29 : Wed Jan 12 2000 - 12:00:22 EST