Hello!
I am working with a four port
21140 and I get message after message of
eth0 Transmitter Stopped! <Then a print of CSR5 and CSR6>
A single port card of the same type works,
but when I put the multi-port in, bad things happen.
Do I have to modify the /etc/conf.modules to look like
this:
alias eth0 tulip
alias eth1 tulip
alias eth2 tulip
alias eth3 tulip
Has anyone had any experiences with multi-port cards
in the past?
I would give a print out of a the diag output but it is
jarbled with the Transmitter stopped messages.
Thanks,
-- Mike B.
This archive was generated by hypermail 2b29 : Wed Jan 12 2000 - 12:00:22 EST